Overview
Made in the USA, the Bob’s Machine Shop Prop Nuts are a convenient, easy to install trolling motor accessory that works to boost performance and reduce noise. Precisely machined on a state of the art Doosan CNC turning center for minimized tolerances, the Bob’s Machine Shop Prop Nut simply replaces stock prop nuts, and requires no tools for installation. Offered in a range of sizes to accomodate all Minn Kota and Motorguide trolling motors, the Bob’s Machine Shop Prop Nuts are designed with 25% more mass than other aftermarket prop nuts, decreasing engine vibration and creating a quieter fishing experience.
Taking innovative design a step further, the Bob’s Machine Shop Prop Nuts feature a center access hole, which allows anglers to insert a screwdriver into the shaft and spin the nut in case of a shear break. Making maintenance a breeze, the Bob’s Machine Shop Prop Nuts allow anglers to clear off fishing line, weeds, and change props in seconds. Offered in a number of custom colors, the Bob’s Machine Shop Prop Nuts are a no-brainer for anglers who want the best possible performance out of their trolling motor.
Please Note :
-Motorguide model fits all Motorguide trolling motors models.
-Prop Nut may not be compatible with all aftermarket props
Previous Feedback
Comments: Sorry to say but this nut cost me a prop, backed off my trolling motor and prop came off. I had tightened it several times before.
From: Randall : United States 7/16/23
Comments: Have one for my ghost and seems to loosen after awhile. I've tried reaching out to the manufacturer with no response.
From: Andrew: IL 1/21/23
Comments: Motorguide nut does not fit the Katana prop on the new tour pro. It was fine on my tour 82 with a machete on the shaft. Yes it's the same thread but I won't put it on my new motor because of the katana being not relieved the reviewer below might have two threads holding his prop on. Works perfectly on any other.
From: Unknown: Ojai, CA 4/20/22
Comments: Motorguide owners beware: If you have the katana prop the nut doesn't fit perfectly. The nut is designed to go with the factory original machete prop. I do have mine paired with the katana prop and it still works fine but just beware it's specifically designed for the machete not the katana prop.
From: Chad: Spencerport, NY 11/27/21
Comments: Just got this for my 80lb thrust minnkota & very easy to put on. Went out on the water & the noticed the motor to run smoother & much quieter.
From: Unknown: 5/21/20